Oil service reset Ford C-MAX

  1. Turn the ignition to run (one position before starting engine).
  2. Press the brake and gas pedals at the same time; after 3 seconds the “Service: Oil reset in prog.” message will appear and after 25 seconds the “Service: Oil reset complete” message will appear.
  3. Release the brake and gas pedals.
  4. Turn the ignition off and then start the engine to verify the indicator has been reset.

Oil service reset Ford F-150

1. Turn the ignition on (do not start the engine).
2. Press and release the SETUP button to display “OIL LIFE XXX% HOLD RESET = NEW”.
3. Press and hold the RESET button for two seconds and release to reset the oil life to 100%.
4. Turn the ignition off and then start the engine to verify the indicator has been reset.

Oil service reset Ford Escape

1. Turn the ignition to the on position (do not start the engine).
2. Press both the accelerator and brake pedals at the same time.
3. Keep both pedals fully pressed.
4. After three seconds, the Service: Oil reset in prog. message will be displayed.
5. After 25 seconds, the Service: Oil reset complete message will be displayed.
6. Release both the accelerator and brake pedals.
7. The Service: Oil reset complete message will no longer be displayed.
8. Rotate the key to the off position. For vehicles with push-button start, press the start button to turn the vehicle off completely.

Mondeo Focus Transit Service Light Reset

Do you own a MK4 Mondeo, New Shape Transit or MK2 face lift Focus?

Do you do your own servicing or have had it serviced and still have the oil service light on?

Here are the instructions to switch off the service light:

THIS INFORMATION IS ONLY TO BE USED AFTER YOUR VEHICLE HAS BEEN SERVICED.

Turn the ignition on (engine not running but dash lights illuminated).

Turn the ignition off.

Press down both the Accelerator (Throttle) and Brake peddles.

Turn the ignition on (engine not running but dash lights illuminated).

Keep both the Accelerator (Throttle) and Brake peddles held down for between 15 and 30 seconds.

Turn off ignition.

Release peddles.

Turn the ignition on (engine not running but dash lights illuminated).

Your service light should now be out.

Reset the oil service light 2011 Ford Fiesta

To reset the oil service light, use the following procedure:

1. With the ignition in the off position, press the brake and accelerator pedals.
2. For keyed vehicles, turn the key to the accessory position; for pushbutton start vehicles, press the Start/Stop button once quickly. Do not start the engine.
3. Press the accelerator and brake pedals fully for 20 seconds.
4. “Engine Oil Change Due Next Service” and the oil service light will display.
5. Turn the vehicle off. The message and lights will be cleared.

Normal Maintenance

Under what Ford terms “normal” conditions, oil changes will occur at a maximum of every 10,000 miles (16,000 kilometers) or 12 months. Other services to be performed at every oil change include:
• Rotate tires.
• Inspect wheels and related components for noise, wear, looseness or drag.
• Inspect brake pads, shoes, rotors, drums, brake linings, hoses and parking brake.
• Inspect engine cooling system for strength; inspect cooling system hoses.
• Inspect exhaust system and heat shields.
• Inspect half-shaft boots.
• Inspect and lubricate steering linkage, ball joints, suspension, tie-rod ends and U-joints if equipped with grease fittings.
• Inspect cabin air filter (if equipped).