Oil service reset Fiat Ducato 3

How to reset warning service light on a Fiat Ducato III.

Scheduled servicing ( service ) Fiat Ducato third generation.

Through this function it is possible to display information connected to proper vehicle servicing.

Proceed as follows:

  • Briefly press button MODE: service in km or mi, according to previous setting, will be displayed see paragraph “Units”.
  • Briefly press button MODE to go back to the menu screen or press the button for long to go back to the standard screen.

The “Service schedule” plans different service intervals according to engine models; service interval is displayed automatically, with the ignition key at MAR, starting from 2,000 km (or 1,240 mi) from this deadline and it is shown again every 200 km (or 124 mi). Oil change warning messages are displayed in the same way. Use buttons ▲ and ▼ to display alternately service schedule info and engine oil change info. Below 200 km servicing indications are displayed more frequently. Service indications will be displayed in km or mi according to previous unit setting. When a programmed maintenance interval (coupon) is near to come, turning the ignition key to MAR, the display will show the message “ Service ” followed by the number of km/mi to go before vehicle servicing. Contact a Fiat Dealership to carry out any service operation provided by the “Service schedule” and to reset the display.

Oil service reset Fiat Ducato

1. Turn ignition to on without starting the engine.
2. Press and hold the button situated in right side of the dashboard.
3. The button must be held down for about 10 seconds until the display shows a spanner and CFG 1.
4. Release the button and then press it again and hold down for about 5 seconds until the CFG1 and wrench key will disappear.
5. Done, you managed to resetservice spanner light Fiat Ducato 2.

Oil service reset Toyota Venza

1. Switch the display to the trip meter A when the engine is running. See below picture.
2. Vehicles with smart key system: turn the “ENGINE START STOP” switch off. Vehicles without smart key system: turn the engine switch to the “LOCK” position.
3. Vehicles with smart key system: while pressing the trip meter reset button, set the “ENGINE START STOP” switch to IGNITION ON mode but do not start the engine because otherwise the reset mode will be canceled. Continue to press and hold the trip meter reset button until the trip meter displays “000000”.
4. Vehicles without smart key system: while pressing the trip meter reset button, set the engine switch to “ON” position but do not start the engine because otherwise the reset mode will be canceled. Continue to press and hold the trip meter reset button until the trip meter displays “000000”.
5. See below picture with trip meter reset button.