Category: Renault

Reset the service indicator light 2007 Renault clio

Turn on the ignition, but don’t start the car. On the right stalk there is a toggle switch that hinges up and down, and is used for going through the different features of the display. When the display shows ‘Service Due’ press and hold the top part of this switch for 10 seconds until the dispaly resets and it shows 30,000km or whatever until next service.
Turn on the ignition, but don’t start the car. On the right stalk there is a toggle switch that hinges up and down, and is used for going through the different features of the display. When the display shows ‘Service Due’ press and hold the top part of this switch for 10 seconds until the dispaly resets and it shows 30,000km or whatever until next service.

all of the above is correct apart from pressing the toggle button. if you instead press the bottom toggle button for 10 seconds the display will start to flash. Keep button depressed and 5 seconds later the service counter will reset.

Reset service light Renault Twingo 2007

The service light on these vehicles is usually a spanner / wrench symbol. To reset that indicator:

Turn the Ignition ON (position 2) but do not start the engine

(On cars with keycard ignition, insert the card, then press and hold the start button for 5 seconds to turn on the dash cluster)

Press the button on the end of the wiper stalk repeatedly until the spanner symbol and miles to service appears on the display

(Some models have 2 buttons, which cycle through the options in opposite directions – either button can be used in this case)

Press and hold the button

The display will now change to the new service interval and start flashing

Keep holding the button until the display stops flashing

Release the button

Renault Scenic service indicator light reset

To reset the service indicator on the scenic II is as follows:
Scroll through the trip computer using the button on the end of the right hand stalk control until you get to the miles till service indicator (or the “change oil soon message” will appear if due)
Then press and hold the same button in and hold it. The miles indicator will then flash then change to 18000, keep the button pressed until the 18000 stops flashing.

NOTE: If the word “service” appears on your dash then that does NOT mean that a service is due. It is an indication that the vehicle is faulty and has a stored major fault code.

The indicator that a Service is due is when the words “change oil soon” appears or the spanner starts flashing.

How to reset service light on 1997 to 2005 Renault Clio 2 – 1.2

Engine should be off, hold down both buttons at the end off stork.

Switch on still holding buttons down then switch off then press buttons ten times. The new mileage will show.

If it’s just the spanner flashing on the dashboard then it’s easy to reset.

Scroll through display using button on end of wiper stalk until you get to the remaining mileage.

Press and hold button until display flashes to new service mileage.

Keep button held until the spanner stops flashing and let go of button.

Turn ignition off and on to check, bingo!!

You can reset the SERV/MIL light by disconnecting battery negative for 20 seconds but you need to recode your radio, and if fault is still active it will come back on again

Service Light Reset – Renault Safrane

The reset button is located on the bottom right hand side of the Rev counter on the instrument cluster.

Switch ignition on.

Press reset button until “spanner “ symbol flashes.

Keep button depressed until “spanner” symbol stops flashing and remains illuminated.

Indicator shows appropriate service interval.

Release reset button.

Switch ignition off.

Some vehicles are fitted with a ‘SERV’ lamp – this is not a service interval indicator lamp, it is a malfunction indicator lamp (MIL).