Oil service reset Jeep Wrangler

Reset oil Jeep Wrangler warning light that appears in the dashboard of your car can be reset manually without using a computer or other device costly after an oil change.

Follow these instructions to reset service interval Jeep Wrangler / turn off service indicator Jeep Wrangler (after an oil change):

  1. Turn the ignition to run (one position before starting engine).
  2. Fully depress the accelerator pedal slowly three times within 10 seconds.
  3. Turn the ignition off and then start the engine to verify the indicator has been reset.

This reset is required to be made only after the engine maintenance performed by replacing oil and filters corresponding engine that comes with your vehicle. This operation must be performed by a qualified and experienced to not cause serious damage to the engine and the risk can not be used.

Leave a Reply

Your email address will not be published.