Turn Off an Oil Light on a 2005 KIA Spectra

Instructions

1. Pull the vehicle over to a safe area, if the light comes on while driving. If you are very close to a store that sells motor oil, stop there. Do not continue driving with the indicator light lit, as severe engine damage may occur.

2. Turn off the vehicle’s engine and open the hood. Locate the oil filler cap and oil dipstick on the top-front of the engine.

3. Check the engine oil level on the oil dipstick. If the engine oil is low, remove the oil cap and add oil until the oil level on the oil dipstick reaches the “Full” mark.

4. Replace the oil cap and restart the Kia. The oil light should turn off within a few seconds of starting the vehicle.

Renault Scenic service indicator light reset

To reset the service indicator on the scenic II is as follows:
Scroll through the trip computer using the button on the end of the right hand stalk control until you get to the miles till service indicator (or the “change oil soon message” will appear if due)
Then press and hold the same button in and hold it. The miles indicator will then flash then change to 18000, keep the button pressed until the 18000 stops flashing.

NOTE: If the word “service” appears on your dash then that does NOT mean that a service is due. It is an indication that the vehicle is faulty and has a stored major fault code.

The indicator that a Service is due is when the words “change oil soon” appears or the spanner starts flashing.

Service oil reset Honda S2000

2000-2005
Turn the ignition off.
Press and hold the TRIP METRE RESET button while you turn the ignition switch to run (one position before starting engine).
Continue holding the button until the indicator resets (indicator light goes out).
Turn the ignition off and then start the engine to verify the indicator has been reset.
2006
Turn the ignition to run (one position before starting engine).
Press the TRIP button until the engine oil life indicator is displayed.
Press the trip button for more than 10 seconds. The engine oil life indicator and the maintenance items code(s) will blink.
Turn the ignition off and then start the engine to verify the indicator has been reset.
2007
Turn the ignition to run (one position before starting engine).
Press the TRIP button until the engine oil life indicator is displayed.
Press the trip button for more than 10 seconds. The engine oil life indicator and the maintenance items code(s) will blink.
Press the TRIP button for more than 5 seconds. The maintenance items code(s) will disappear, and the engine oil life will reset to “100”.
Turn the ignition off and then start the engine to verify the indicator has been reset.