Reset the Range Rover Airbag Fault Code

Instructions

1. Open the hood and loosen the retaining nut on the cable clamp running to the negative battery terminal.

2. Slide the clamp off of the negative battery terminal.

3. Wait 1 minute for the Range Rover’s electronic control module to cycle and reset. Then, reconnect the clamp to the negative battery terminal.

4. Tighten the retaining nut on the cable clamp. The airbag light should go out at this point. When it does, you’ll know that the fault code has been erased.

Oil service reset Land Rover Range Rover

2005-2009

Manual Reset Procedure:
Press and hold the trip reset button.
Turn the ignition switch on to the ignition position II (one position before starting engine).
If the SII (Service Indicator Interval) function is enabled the information display will flash ‘SERVICE’ for 5 seconds and then display ‘SERVICE’ constantly. If the SII function is not enabled the information display will show the normal odometer and trip information.
If the trip reset button is released within 10 seconds of entering the reset mode, the information display will show ‘DIST’. If the trip reset button is not released after 10 seconds the instrument cluster will exit the manual reset procedure.
If the oil service value is to be reset, press the trip reset button within 10 seconds for 5 seconds and then reset the oil service value, the display will then show ‘END’.
If the trip reset button is pressed for 5 seconds the display will exit the reset routine. If the trip reset button is not pressed for more than 10 seconds, then the information display will exit the reset routine. Turn the ignition off and then start the engine to verify the indicator has been reset.

Service oil reset Chevrolet Camaro

1999-2002
Turn the ignition to run (one position before starting engine).
Press and hold the AVERAGE SPEED and RANGE buttons until the display resets to 100.
Turn the ignition off and then start the engine to verify the indicator has been reset.

2010
Turn the ignition to run (one position before starting engine).
Immediately after Step 1 press and release the gas pedal 3 times within 5 seconds.
If the “Change Engine Oil Soon” message is not on, the system is reset. If it is on, turn the ignition off and repeat steps 1-2.
Turn the ignition off and then start the engine to verify the indicator has been reset.

Service oil reset Cadillac Allante

1989-1993
Turn the ignition to run (one position before starting engine).
Press the range button until the OIL LIFE INDEX is displayed.
Press and hold the AVERAGE SPEED and RANGE buttons until the display resets to 100.
Turn the ignition to off and start engine to verify the indicator has been reset.

How do you How do you reset the service reminder indicator light on a 2007 range rover sport?

turn off the car’s ignition.

Hold down the reset button on the dash board to zero the mileage.

keep it held in.

turn the car’s ignition on – but do not start.

keep the button in for 5 seconds.

a menu will come up – like date/mileage.

let go and then press the button again.

it will toggle through some options – then get to ‘rst’

press the button again, and your done