Reset the service indicator light 2007 Renault clio

Turn on the ignition, but don’t start the car. On the right stalk there is a toggle switch that hinges up and down, and is used for going through the different features of the display. When the display shows ‘Service Due’ press and hold the top part of this switch for 10 seconds until the dispaly resets and it shows 30,000km or whatever until next service.
Turn on the ignition, but don’t start the car. On the right stalk there is a toggle switch that hinges up and down, and is used for going through the different features of the display. When the display shows ‘Service Due’ press and hold the top part of this switch for 10 seconds until the dispaly resets and it shows 30,000km or whatever until next service.

all of the above is correct apart from pressing the toggle button. if you instead press the bottom toggle button for 10 seconds the display will start to flash. Keep button depressed and 5 seconds later the service counter will reset.

Reset Service Message Volvo S80

S80

Turn ignition switch to position I
Press and hold “day counter reset button”
Turn ignition to position II
Continue holding day counter for about 10 seconds
While SRL flashes, release day counter button
Should hear “beep-beep” to confirm command accepted

ibiza/cordoba 93-99 service indicator system

SERVICE INTERVAL DISPLAY

the computer has counters that not only count the miles from the speedo but also
a time count as well

Displays:

IN00 – No service is required – standard display

OEL – When 7500 miles has been reached before the yearly service is required

IN01 – Indicates time for the yearly service inc oil change

IN02 – Indicates it is time for the Major service

TO RESET THE INDIVIDUAL COUNTERS

1- turn on ignition (do not start)

2- Press the trip-reset button button on the speedo (the trip value will not reset to
zero but will reappear when the procedure is finished)

3- Turn off the ignition and thne release the trip-reset button

In the LCD display you will see the word “OEL”

Using the minute set button for the clock (lower one) you will reset the OEL interval
counter

press it – hold – release – 5 horizontal lines will appear in the display

4- press and release the trip-reset button

In the LCD display you will see “IN01” repeat step 3 to reset the inspection counter when required

5- Again press the trip-reset and rest the “IN02” counter if necessary

If doing an oil change only reset the “OEL” counter

If doing an inspection service reset both the “OEL” and “IN01” counters

If doing a full service reset all 3 – “OEL” “IN01” & “IN02”

6- Turn on ignition (do not start the car)

7- After the appearance of the “IN00” display turn off the ignition

8- You are done – the trip counter should read as it did before you started

PROGRAMMING THE INTERVALS TO REQUIREMENTS

With todays higher spec oils and/or peoples need and desire to service more regular there is a way
to alter the counters to your prefered settings (within reason)

1- Turn on ignition (don’t start the car)

2- press the trip-reset button also press the Minute set button on the clock (lower one)

3- The LCD display “OEL 1,S” where the “S” indicates SET

4- Using the trip-reset button you can call up the following counter data in sequence

OEL 1,S – Distance counter for oil change (7500 standard)

OEL 2,S – Time counter for oil change (12 months)

IN 01,S – Time counter for yearly service interval (12 months)

IN 02,S – Distance counter for full service (15000 miles)

5- Using the minute SET button on the clock (lower one) you can display the current value
repeated pressing of the button will select a subsequent lower value and at the lowest level
will reset to the highest and start to decrease again (so don’t panic)

the steps work in miles (500 at a time) and time steps in bi-monthly (1=2months) i.e.1-2-3-4-5-6

6- Once you have set the counter to the value you require – turn off the ignition

7- Job done

service light reset Volvo

Volvo 1999-2000 – S / V / C70 Models

Press and Hold odometer reset button
Turn ignition switch to “run” position
After SRL flashes, release odometer reset button
Turn ignition off
Turn ignition back on to confirm reset

Volvo 1998 – S80 Models

Turn ignition switch to position 1
Press and hold the odometer reset button
Turn ignition switch to position 2
Wait until service light blinks and then release odometer button

Volvo 1999-2000 – S80 Models

Turn ignition switch to position 1
Press and hold “day counter reset button”
Turn ignition switch to position 2
Continue holding day counter for approx. 10 seconds
After SRL flashes, release day counter button
Should hear “beep-beep” to confirm command accepted

Volvo 2001 – XC 70 Models

The following steps must be completed with no longer than 5 seconds between each step:
Make sure the trip meter is in T-1
Turn ignition key to position 1
Press and hold trip meter button until zero is shown
While still holding the trip meter, turn key to position 2
When original trip mileage returns, release the trip reset button
Turn key to off