Oil Reset, Oil Light Reset, Oil Life, Reset Maintenance Light
Complete instructions on how to reset the oil service engine indicator of most car brands without the use of an additional computer
1. Turn the ignition switch to the “On” position without starting the engine.
2. Press the odometer reset button repeatedly until the total mileage is displayed.
3. Turn the ignition switch to “Off.”
4. Press and hold the trip odometer reset button.
5. Turn the ignition switch to “On.” Do not start the engine.
6. Release the trip odometer reset button after the service display counts down from 10 to 0 and the service light resets.
Switch Ign on (do not start engine)
Set Odometer to read total miles.
Press Odometer Button (OB) until CFG1 appears in display
Release the OB.
Pressing the OB briefly will change between CFG1, CFG2, CFG3, CFG1
Once you have selected the CFG (see below).
Press the OB again for 5secs to store the new service frequency.
Turn off the ignition.
I selected CFG1 for my vehicle (05 Reg 2.8JTD), but you must decide yourself for your vehicle, should take 5mins to read this and carry out the resetting procedure
Note: If your vehicle is under warranty and you take it to be serviced by a Fiat dealer they will do this as part of the service.
CFG1 = 30000km (18,600mi) and 365 days in cases of Standard Use for 2.0 petrol and 2.8JTD versions, or in the case of Severe Use for the 2.3JTD versions.
CFG2 = 20000km (12,500mi) and 365 days in case of Standard Use for 2.0JTD versions, or in case of severe use for 2.0 petrol and 2.8JTD versions
CFG3 = 15000km (9,300mi) and 365 days in case of Severe Use for 2.0JTD versions
1) Ensure ignition key is turned off.
2) Press and hold the odometer reset button whilst turning the ignition switch to the on position.
3) Keep the odometer reset button pressed for 10 seconds whilst the service display counts down from 10 to 0. When the count down reaches zero the spanner icon will vanish from the display and the service indicator will be reset.
BMW X5 Engine Oil Service reset
Turn the ignition to “0”
Press and hold odometer button and turn the ignition to “1”.
Hold odometer button pressed for approximately 5 seconds until the display shows: “Inspektion Re /
Release and press odometer button again until Reset flashes
Release and press odometer button shortly.
Release and press odometer button again.
The next oil service interval will be shown and will disappear.
Oil service lamp is now reset
Note: To abort the procedure at any time: turn the ignition to “0”.
S40 and V40 (1999+)
1. Hold down the odometer button
2. Turn the ignition so all the lights come on
4. Keep holding the odometer down for 30 secs or until the service light starts flashing
5. Release the odometer button while service light flashing
6. Turn off and on again to check