1. Turn the ignition key to ON but do not start the engine.
2. Slowly depress the accelerator to the floor and release it three times within 10 seconds.
3. Turn the ignition key to the OFF position.
Tag: change
Renault Scenic service indicator light reset
To reset the service indicator on the scenic II is as follows:
Scroll through the trip computer using the button on the end of the right hand stalk control until you get to the miles till service indicator (or the “change oil soon message” will appear if due)
Then press and hold the same button in and hold it. The miles indicator will then flash then change to 18000, keep the button pressed until the 18000 stops flashing.
NOTE: If the word “service” appears on your dash then that does NOT mean that a service is due. It is an indication that the vehicle is faulty and has a stored major fault code.
The indicator that a Service is due is when the words “change oil soon” appears or the spanner starts flashing.
Reset service light oil change interval on Renault modus 1.5 dci
Reset
//// go to oil substitute thuson press up arrow on wiper switch since a few seconds distance until next service appears. then it will reset back to 12000 miles hope this contribute tos modus 1.5 dci
Reset the service indicator light on Renault Megane Scenic 2005
If you mean the spanner symbol & message such as ‘change oil soon’ just scroll through your trip computer as you do when you zero your trip mileage when you fill up with petrol.
(press top button of right hand stalk).
Scroll through trip mileage/ averages etc until you get to the change oil message and then clear it the same way you clear your trip mileage by holding the button in until the message flashes & clears.
Reset computer after oil change on 2006 bmw 325xi
Turn the car on. Wait about a minute for the computer to get to normal.
press and hold the travel mile reset button. Hold it untill an ! in a triangle appears. then your maintanance info will pop up. select the item to reset. and tap the side button on the wand atached to the stearing wheel. this button is what you use to browse through your computer. press the button once it will say “reset” press and hold it the second time and it will say reset, hold for 5 seconds or so and it will show a check mark next to “reset” confirming it has reset.