RESET SERVICE INDICATOR SEAT INCA

Hot to reset service light on a Seat Inca

Try this.

Switch on the ignition.

Press the left hand button on the clocks and hold it in while switching off the ignition.

Release the button and you should be able to toggle between the oil, insp1 and insp2 indicators.

Choose the one you want to reset.

On the right hand side of the clocks there is two buttons.

Press and hold the bottom button with a biro and hold it until the display is reset.

RESET SERVICE INDICATOR SEAT AROSA

Hot to reset service light on a Seat Arosa

The SEAT owners manual for the Arosa states.

With the ignition switched off, press and hold the trip meter reset button below the speedometer.

Then, switch the ignition on and hold the reset button for atleast 10 sconds.

Dashes will then appear in the display.

The service has been reset.

Reset the Oil Life on My Suzuki XL7

Instructions

1.Sit in the driver’s seat of the XL7. Insert the ignition key and turn it to “RUN.” Do not start the engine.

2.Press and release the gas pedal three times within five seconds. Watch for the engine oil light to flash, indicating that the system is reset.

3.Turn the key to “OFF” and remove it from the ignition.

Service reset VW Crafter 2.5 td

VW Crafter service reset Sitting in the drivers seat looking at the dash on the left hand side you have a M button and below it a 0 button these are the buttons you will need to use.

When i refer to the LCD this is the illuminated part in the middle that shows your mileage,service mileage and trip mileage.

Please read this fully first to get the jist of it as if you perform the actions too slow it wont work and you will have to start over.

1.Put on ignition

2.Wait for service mileage to revert to vehicle mileage

3.When it reverts to the vehicle mileage press and hold the 0 button until you hear a beep (can take up to 30 seconds)

4.As soon as you hear the beep press the M button repeatdly and you will see in the LCD display different reset’s the one you need to select is “reset 51” if you go past it just keep pressing the M button till it comes up again.

5.When the “reset 51” is displayed stop pressing the M button then press and hold the 0 button again until a number 2 is displayed in the LCD.

6.Release the 0 button and then press twice and it will say in the LCD reset done ,if it is not reset you will get a 30% power reduction after 2K miles